Quality 1 Auto Service: Doing It Different!

Temecula Auto Repair

(951) 972-8279
Mon - Fri: 8:00 AM - 5:00 PM
24/7 ROADSIDE ASSISTANCE

Yearly Archives: 2020

The Need for Speed (Wheel Speed Sensor Maintenance)

Today's vehicles have some pretty amazing technology in them, including a computerized braking system we all pretty much take for granted these days.  Antilock brake systems (ABS) have been around for years but they help drivers stop in much shorter distances reliably than ever before.  When you see your ABS warning light come on, it's important to find out what's causing the problem. It's a safety issue. Often the problem when the ABS light comes on is a faulty wheel speed sensor.  (In some cases the traction control light will also come on, perhaps because of a non-working wheel speed sensor.) Your vehicle uses the speed sensors to measure the rotational speed at each wheel. That sensor sends the speed data to a computer that can then adjust braking power and prevent your wheels from locking up.  If any of the wheel speed sensors isn't working right, the ABS warning light will go on and the vehicle's computer will turn off the antilock brake system.  You'll s ... read more

Categories:

Brakes

Why Alignment Matters (Vehicle Alignment Maintenance)

It's one of those things that can happen on a multi-day road adventure or a quick trip to the grocery store.  You hit a pothole, go too fast over a speed bump, nail a curb.  When it happens, you think, "I wonder if that was hard enough to do any damage?"  But things seem ok and you continue on your way.  Keep in mind that any blow to your vehicle's suspension can throw it out of alignment.  It can be a hard knock from the road or from another vehicle, such as being involved in a minor accident.  When your suspension is out of alignment, it means that the wheels aren't all pointing where they should.  And after a while, it can make your tires wear unevenly and cause problems with steering and handling. Let's go back to that pothole or curb you hit hard.  Even though you think there was no damage done, if you wait until you see tire wear, you may need to replace all four tires, not an inexpensive proposition. That's why it's a good idea to make sur ... read more

Categories:

Alignment

3 Winter Windshield Tips (Care of Windshield)

Cold weather can present some real challenges when it comes to your vehicle's windshield.  Think of it.  Your windshield is your window to the world when you're driving, and clear visibility is extraordinarily important for safe travels. So here are 3 tips to ensure that your windshield can do its job during the cold weather. Don't ever pour hot water on a frozen windshield.  Let's say you head outside and see your vehicle covered with ice. You think, hey, maybe I can heat up a pot of water on the stove and melt that off fast.  Don't do it!  You run the risk of shattering the glass the second that hot water hits the frigid glass.  Ditto for using a propane torch.  Glass does not do well with sudden temperature changes.  Instead, turn on your engine and start the defroster, which heats the windshield up gradually.  Use a plastic scraper designed for windshields (don't EVER use metal to scrape) and be patient.  Don't hammer on the ice to ... read more

Visibility Disaster! (Windshield Washer Pump Replacement)

Let's say you live in a cold climate where the snowy, icy weather challenges you to clear the salt and debris tossed up on your windshield.  You push your windshield washer switch expecting a good stream of fluid so the blades can wipe the glass clean. Yet nothing comes out.  Nada, zip.  What's going on? You know you filled up the windshield washer reservoir within the last week or so.  Well, there could be a few things causing your windshield washing system to fail.  One culprit? The hoses that are supposed to carry that fluid from the washer pump to the spray nozzles may be frozen, or maybe they're cracked and leaking. It could be the nozzles themselves are stopped up, either iced up or jammed full of debris.  Your windshield wiper/washer switch could be worn out or the electrical system may not be conducting power to the washer pump.  It's important that this system work properly, especially on days when the sun may be in front of you and your wind ... read more

H20 No! (Driving Through Standing Water)

In a year marked by unusually heavy flooding in North America, drivers are very aware of the possibility they may find themselves driving where water has come over the road.  It can be a daunting and frightening situation.  Flooding waters can move quickly and unpredictably, so you have to keep your wits about you when you encounter that situation. Here a sample of one vehicle manufacturer's guidelines on what to do.  First, the vehicle is designed to go through some water, but you must be careful.  Never attempt to drive through water deeper than the bottom of your tires. You can get out of your vehicle to check the depth of the water, but you can never be sure that you aren't going to drive into a spot where the road has washed away.  You can't see below the surface of the water, and suddenly you could find yourself in a place where the road drops off unexpectedly.  In swift moving storm runoff, your vehicle could literally be floating away with the curr ... read more

No Fueling! (Fuel Filler Location)

If you've ever gotten in an unfamiliar vehicle, maybe a rental car, you may have pulled up to the gas pump and wondered, "Which side is the fuel filler on?" Here's a tip for you.  There is usually a little arrow on the instrument panel near the fuel gauge that points to the side where the fuel filler is.  But why are the fuel fillers not all on the same side, anyway? There are lots of reasons.  At one time, many manufacturers tried putting them in an easy-to-reach spot: in the center of the vehicle's rear end.  Some even hid them behind a hinged license plate door.  Cool place, but it turned out not to be a good idea.  When a vehicle with a fuel filler in the rear was hit by another vehicle from behind, it was much more prone to catch fire and explode. Safety regulations now dictate that the fuel filler doors be placed within crumple zones and away from where they can drip fuel on hot exhaust pipes or near electrical connections.  But why do manufactu ... read more

In the Hot Seat (Repair and Maintenance of Seat Heaters)

It's chilly outside. You flip on that switch that looks like a picture of a seat with little heat waves rising from it.  You expect soon you'll feel that warmth but… wait! It's not getting warmer.  Oh no, what's wrong with my seat heater? There could be lots of reasons it's not working, and it could be as simple as a fuse or as major as the heating element itself.  But it's something to leave to a pro to diagnose and repair. Let's say it turns out to be a blown fuse.  Simply replacing the fuse may not fix it because there was a reason the fuse blew in the first place.  It's possible the on-off switch has worn out or corroded.  Perhaps the wiring connection isn't completing the circuit (could be corroded or full of dirt) or the voltage reaching the heating element isn't correct.  There's a little sensor that keeps track of the seat heater's temperature called the thermistor.  When the seat is hot enough, it will stop the juice from heating ... read more

Chilly Warning (Diagnosing a Noise in Cold Vehicle)

When the weather gets colder, sometimes the noises your vehicle makes will change.  For example, you may notice a whining sound when you get going in the morning.  It may go away when the vehicle warms up, but it's best not to ignore that sound because it could be a warning of worse things to come. Colder temperatures cause different components to behave differently.  Let's take a look at a few of them.  First, the fluids in your vehicle.  Cold temperatures can make them behave a little differently, such as engine oil, transmission fluid and power steering fluid. Those characteristics could change if the fluids are older and full of contaminants. Belts also can create a whining noise when cold.  Since they turn pulleys that move other things, several factors can create issues.  Increased friction can change proper tensions on belts.  Plus, belts change as they age and may crack, get loose or develop a glazed surface. Belts and pulleys also must b ... read more

Rear Window?Not the Movie! (Why Some Rear Windows Don't Go All the Way Down)

Alfred Hitchcock once made a mystery thriller film called "Rear Window." It had nothing to do with the rear window of today's cars, SUVs, CUVs and light trucks.  But there is one thing that some drivers DO find mysterious.  Why don't the rear windows in the second row of many of these vehicles go down all the way? You've probably seen or owned one or two. That rear side window only goes down about a third, a half or three-quarters of the way. Yet there are some similar vehicles where the window goes down all the way.  What gives? There was the rumor going around that the restriction on how far those windows could go down was a child safety feature.  The thought was that if those windows couldn't open up fully, a child (or pet) would be less likely to fall out.  But it turns out the real reason is that the way the rear doors were designed, there was just no room for the window to go down all the way into. Many vehicles are configured so that the rear wheel arch ... read more

Quality 1 Auto Service Inc is committed to ensuring effective communication and digital accessibility to all users. We are continually improving the user experience for everyone, and apply the relevant accessibility standards to achieve these goals. We welcome your feedback. Please call Quality 1 Auto Service Inc (951) 296-1222 if you have any issues in accessing any area of our website.