Temecula Auto Repair

You might be familiar with brake pads and rotors, two components of your vehicle's brakes that have to be regularly serviced.  Here's another important component of your brakes: the calipers. Calipers are used in disc brakes, the type of brakes now found in most recently manufactured vehicles.  A caliper is the part of the brakes that squeezes the brake pads against the discs, or rotors, which turn with your wheels.  There are different kinds of calipers, but the basic principle is the same.  You press down the pedal, brake fluid activates a piston or pistons that squeeze the brake pads against the disc and the friction slows down your vehicle. While modern vehicles have a warning system to let you know it's time to get your brakes checked, your brake light usually goes on when your fluid level is low or your fluid pressure is low.  But you may have to look out for signals your calipers are the problem.  If your vehicle pulls to one side when you brake, th ... read more

Changing your oil regularly is one of the most important things you can do to keep your vehicle running well.  And knowing the right type of oil to use is also very important.  Engine oil is classified by weight, but it doesn't refer to how much the oil would weigh if you put it on a scale.  It refers to viscosity, or how easily the oil flows through the engine.  Most engines operate normally at around 210°F/99°C.  The viscosity, or weight, is assigned a number by how well it flows at that temperature.  The lower the number, the more freely it flows.  Most vehicle engines use what's called a multigrade oil which behaves differently in different temperatures. Multigrade oils have a "W" in their viscosity number that you may have seen on a bottle of oil, something like 5W30.  The W stands for winter and shows how freely it flows in colder temperatures. That means a 5W30 oil will behave like a 5 weight oil in lower temperatures (less viscous ... read more

For drivers, S stands for safety.  And there are three other words that start with S that are all equally important: starting, stopping and steering. For your vehicle to be at its safest, all three functions must be in top shape.  Steering is one of those things we take for granted.  After all, you turn the wheel and your vehicle changes direction. But sometimes you might notice your steering is a little off.  Maybe you've noticed you turn your wheel slightly and your vehicle doesn't turn. You may feel a little vibration in the wheel that increases when you go faster.  You may hear a little squeak from the wheels when you steer and you may notice your tires aren't wearing evenly. These are signs that your tie rod ends may be failing. Tie rod ends help connect your vehicle's steering mechanism to the wheels.  They can wear out after you've hit one too many potholes or just from constant use.  They can cause sloppy steering and loose handling, and they ... read more

A set of new tires isn't probably high on anyone's list of exciting purchases.  But since your life is literally riding on them, it's probably a good idea to know when it's time for you to buy new ones. If you've been feeling your vehicle slipping more in wet weather or it takes a longer distance to stop, those are a couple of signs you may need new rubber all around. Here's how to make your decision. First thing to do is look at your tires.  The surface of the tire that contacts the road is the tread. When that tire was new, the tread was deep (the grooves in the rubber that provide traction). If they're starting to look somewhat smooth, you have a seriously worn tire that definitely needs replacing.  Bring your vehicle in for us to look at your tires and we can check your tread with a tread gauge. Also look at the sides of your tires.  If they have cuts or cracks in them, or if you see signs of bulges or scrapes made by hitting curbs or potholes, those could be si ... read more

If someone tells you to put the brakes on something, you know it means stop.  And stopping is one of the most important safety maneuvers you can do in any vehicle.  That means your brakes have to work properly.  Let's face it.  You stop dozens of times every time you drive.  And over time, that takes its toll on your brakes.  Friction is what stops your vehicle.  Most newer vehicles have disc brakes, and the parts that wear out the fastest are those that rub against each other every time you stop, the rotors and the pads. The rotors are discs that rotate with the wheels, and the pads are removable surfaces that make contact with the rotors to slow or stop your vehicle.  Bits of both wear off each time you stop, and when enough of either (or both) lose too much material, your brakes become unable to safely slow or stop your vehicle.  The pads usually are the parts that wear out first.  Signs that your brakes might be getting worn are: Y ... read more

One of the most important things you can do to keep your vehicle running safely is to make sure your tires are properly inflated.  If one or more is vastly over- or underinflated, that has the potential to cause major handling problems and may result in a dangerous accident. All vehicles in recent years are equipped with Tire Pressure Monitoring Systems, or TPMS.  One system uses small sensors in the tires that continually check the pressure in each tire.  That sensor sends a signal to computers in your vehicle which turns on an instrument panel light warning of low pressure when at least one is very low. Or it may update a numeric reading on your instrument panel which gives you an approximation of how many PSI (pounds per square inch) of air is in each tire.  Another system works with your antilock brake system to measure the size of your vehicle’s tires.  When one wheel is going faster than another, it will spin faster. A computer sees that and alerts ... read more

It’s just common sense that your vehicle will drive better if all the wheels are lined up with each other and the road the way the engineers intended.  When they’re not, that is called being out of alignment.   Here are some signs that your alignment has problems. Your steering wheel isn’t straight when your vehicle goes straight down a straight road. This one’s pretty easy to notice.  If your vehicle’s logo on the wheel is tilted, that’s probably not the way designers wanted it to be. Bring it in and have us check it out. Your steering wheel is vibrating on a smooth road or when you are accelerating.  While this could be caused by several different things, one possibility is misalignment.  If your steering wheel is shaking, it should be examined by a trained technician. Your vehicle is pulling to one side without you wanting it to.  Sometimes the configuration of the road will cause it to pull slightly left or rig ... read more

Your vehicle is loaded with electrical devices. Computerized components are everywhere, so good electrical connections are important.  Those begin with your vehicle's battery, so it's important that its connections are in top shape. Ever had a flashlight that didn't work, took out the old batteries to replace them and noticed the old batteries were all corroded? The same thing can happen to your vehicle's battery.  The battery type used in most vehicles is a lead-acid, which can be very corrosive.  Corrosion can build up around your battery's terminals that can prevent the electrical connection from being as solid as it needs to be.  You may have even seen discoloration around your battery's terminals if you look under the hood, a sign of corrosion. Or you might notice visible signs of fraying or loose battery cables. All of your vehicle's components are affected by vibrations from the engine and road surface imperfections, and the battery cables take a lot of jostl ... read more

No matter what the weather is like outside, your internal combustion engine expects to keep its cool all the time, even when it's really cold.  That's because engines create the power that moves you to your destination by a series of tiny explosions of a fuel and air mixture. In turn, that generates a lot of heat in a small space. Your vehicle has a complete cooling system with a lot of different parts that work together to keep the temperature at a point where the metal engine parts won't heat up enough to warp.  Its lifeblood is coolant, a liquid that circulates through the engine (and, in most vehicles, the transmission, too) through a series of hoses and tubes.  In order to get rid of the coolant's heat, your vehicle has a part you probably recognize: the radiator.  It does what its name proclaims: radiates heat.  The radiator has a series of thin metal fins that coolant goes through, and when outside air passes over them, the heat is dissipated from the ra ... read more

It's easy to get letters like PVC and PCV mixed up.  PVC is a plastic that's used in a lot of things, especially plumbing pipes.  And PCV is a valve that helps your engine burn off excess fumes rather than having them pollute our atmosphere.  PCV stands for positive crankcase ventilation.  When your engine ignites gasoline in the cylinders, some of the gases produced make their way into the crankcase, where oil is held to lubricate the engine.  In earlier days, those gases would be vented out through a hose and go directly into the air.  It was a waste of gasoline (since about three-fourths of the gases were unburned fuel) and a nasty source of pollution. So engineers devised a one-way valve that directed those gases back into the engine's air intake system to be burned again.  After a while, the PCV valve can get clogged up with gummy oil.  Not only does that reduce the recirculation of the gases, but it can also cause pressure in the crankcase ... read more