Temecula Auto Repair

Every day you drive, you're sitting behind the dashboard. But how in the world did it get that name? Back in the days of the horse-drawn carriage, horses would kick up dirt and mud on the driver and passengers, "dashing" debris against the carriage. So those who built carriages began installing a board to protect them. So, dash-board. Dashboard. The dashboard is still there, though changed quite a bit from the early days. Now its main purpose is to house the controls and instruments for your vehicle's systems. Of course, you have the speedometer, tachometer and gas gauge. But there are four warning lights you need to pay attention to on your dashboard and instrument panel. Some of these may even be gauges, depending on your model of vehicle. Regardless, paying attention to them is a good idea if you want your vehicle to keep going as long as possible. Oil pressure—The oil pressure light will come on if your engine doesn't have enough pressure in its system. Low oil pressure means ... read more

Did you know that most of the cars driving around Temecula, California, carry more computer power than the Apollo 121 Lunar Module that landed on the moon in 1969?New cars sold in the Temecula area have as many as 12 networked computers and over five miles (eight kilometers) of wiring. In fact, for the last decade or so, auto computers have been controlling about 85 percent of your vehicle's functions.Cars have sensors for manifold air temperature, coolant temperature, manifold air pressure, airflow, throttle position, vehicle speed and oxygen content. All of this electronic wizardry is pretty complicated. So how do Temecula drivers know when there is a problem?It's simple; the Check Engine light comes on. The computer monitors all the sensors and uses that information to decide what to adjust such as the fuel mix, spark timing and idle speed. In addition, the computer monitors its own circuits. When it finds a fault, it turns on the Check Engine light and stores a trouble code i ... read more

Have you ever had an experience like this in Temecula, California? You drive through the one of those automatic car washes. When you get to the end, where the dryer is blowing, your Check Engine light starts flashing!You fear the worst, but within a block or two, the light stops flashing, but stays on. By the next day, the light is off.You wonder; "What was going on?" Well, it's actually a good lesson in how the Check Engine light works.Your air intake system has a sensor that measures how much air is coming through it. When you went under the high-speed dryer, all that air was blasting past the sensor. Your engine computer was saying, there shouldn't be that much air when the engine is just idling. Something's wrong. Whatever's wrong could cause some serious engine damage.Warning, warning! It flashes the Check Engine light to alert you to take immediate action.It stopped flashing because once you were out from under the dryer, the airflow returned to normal. Now ... read more